[T2] Electrical problems

accessys at smart.net accessys at smart.net
Thu Jun 16 07:02:27 PDT 2016


gotta bleed em all to be sure it is airless

Bob


On Wed, 15 Jun 2016, Bob Pratt wrote:

> Date: Wed, 15 Jun 2016 20:47:55 -0400
> From: Bob Pratt <ka1dza at verizon.net>
> To: Joseph Delecki <jdelecki at msn.com>
> Cc: type2 at type2.com
> Subject: Re: [T2] Electrical problems
> 
> Hi Joe,
> Thanks for the advice. How do you bleed just the master cylinder? I replaced it last fall about the same time the brake lights stopped working.
>
> Bob Pratt
>
>> On Jun 15, 2016, at 8:50 AM, Joseph Delecki <jdelecki at msn.com> wrote:
>>
>> Bob,
>>
>> I have owned my 71 camper for the last 30 or so years and I have experienced my share of electrical problems.
>>
>> I can find it challenging to localize an electrical problem on the bus due to the age of the components and unusual failure modes.
>>
>> But, just off the top of my head and looking at the electrical schematic ,( I hope you have the one in Bentley) , I would look at the integrity of the voltages going into and out of the flasher relay when
>> doing your tests AND the actual wiring  from the flasher to the bulbs. Many of the circuits you mention in your email  pass through the flasher before going to the various bulbs.  You have to understand how to read an electrical wiring diagram to do the tests with a simple voltmeter.
>>
>> Believe it or not, the one time problem I had with my brake lights not working had to do
>> with when I replaced the brake master cylinder and left some air in the master brake cylinder.
>> Now if I am doing some brake line work I make sure to bleed the master cylinder at the master cylinder. However, you should also be  able to do an electrical test at the flasher to check your
>> brake lighting.
>>
>> Just some thoughts to consider not to confuse………………..
>>
>>
>> Joe
>>
>>
>>
>>
>>
>>
>>
>> Sent from Mail for Windows 10
>>
>> From: Bob Pratt
>> Sent: Tuesday, June 14, 2016 3:03 AM
>> To: type2 at type2.com; accessys at smart.net
>> Subject: [T2] Electrical problems
>>
>> Hi all.
>> I've been trying to troubleshoot the new wiring for a month now. I double, triple, and quadruple checked every connection. I've found a couple of wrong connections, but there are a few problems I can't figure out.
>>
>> All of the directional lights work, but when I turn on the 4 way flashers, only the front ones work. I've changed the switch. The brake lights don't work. I checked the connections on the master cylinder. The oil pressure light doesn't come on. I've changed the oil pressure switch and bulb twice.
>>
>> I've tried everything I can think of. I used "Noalox" on all the connections.
>> It's used to make better mechanical bond.
>>
>> PLEASE HELP!!!!!!!!!!!
>>
>> Bob Pratt=
>> _______________________________________________
>> type2 mailing list
>> type2 at type2.com
>> https://www.type2.com/lists/type2/listinfo
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo
>



More information about the type2 mailing list