[T2] Rebuild Heater Blower?

Kevin Guarnotta kevin at guarnottadesign.com
Sat Jun 18 05:03:05 PDT 2016


I've sprayed all sort of stuff in there - not sure if it is getting to the bearings, but it still sounds/feel gravelly - like the bearings are shot. The whole motor appears to be pressed together - kind of like you are not supposed to take it apart. 

-Kevin Guarnotta
Jamaica Plain, MA

'78 Westy
'69 Singlecab
'65 Ez-camper

-----Original Message-----
From: accessys at smart.net [mailto:accessys at smart.net] 
Subject: Re: [T2] Rebuild Heater Blower?


after WD40 (I prefer CRC) breaks up the crud lubricate the bearnings with a good silicone lube like Triflo.  remember WD40 is NOT a lubricant it is a solvent

Bob

On Thu, 16 Jun 2016, Bob Pratt wrote:

> Date: Thu, 16 Jun 2016 20:58:07 -0400
> From: Bob Pratt <ka1dza at verizon.net>
> Check the bearings first. Give them a little squirt with WD40 and give the fan a couple of spins to see if the frees up the shaft before you tear the motor apart.
>
> Bob Pratt
>



More information about the type2 mailing list