[T2] (no subject)
aroman4047 at aol.com aroman4047 at aol.comFri Jun 28 12:18:40 MST 2013
- Previous message: [T2] push rod tubes
- Next message: [T2] pertronix install
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
I'm putting in a replacement for a failed module in a Pertronix SVDA distributor... Is there a specific orientation for the magnet ring on the distributor shaft? The instructions just indicate to slide the ring down...? Tony in NJ W.A.S.T.E.
- Previous message: [T2] push rod tubes
- Next message: [T2] pertronix install
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the type2 mailing list
