[T2] Removed Westfalia's plywood subfloor
accessys at smart.net accessys at smart.netSat Sep 14 19:11:02 MST 2013
- Previous message: [T2] Removed Westfalia's plywood subfloor
- Next message: [T2] Removed Westfalia's plywood subfloor
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
for the moulding I have had good luck with Outwater plastics www.outwater.com Bob On Sat, 14 Sep 2013, J Stafford wrote: > Date: Sat, 14 Sep 2013 18:02:29 -0700 (PDT) > From: J Stafford <sunbus at sbcglobal.net> > To: "type2 at type2.com" <type2 at type2.com> > Subject: [T2] Removed Westfalia's plywood subfloor > > Good afternoon, > > > To replace the old plywood floor, I sourced 5' x 5' x 12mm birch plywood in > an unfinished state. Trimmed to fit, then primed and painted 5 sides with leftover > > house paint. The 6th side will be painted with glue and the reused linoleum. > And to replace the long interior panel behind the driver, 4' x 8' x 4mm birch ply > sheet. Only one side is finished, from the same lumberyard > > http://www.kelly-wright.com/index.html > The Westfalia plywood furniture is showing some age. It appears to have been > assembled without glue in the joints held together with wire staple fasteners. No > nails, no screws. I'm cleaning, glueing and wire brad nailing it back together > where it has begun to fall apart. > > Alot of filthy grime had made it's way up through the hole in the floor for the sink > drain pipe. The ice box/sink combo bottom piece was a mess. Found some of the > Dempster Hwy in there. The rubber shield to cover up the hole underneath will be > recreated and installed. > > > Questions: > > Should any wood finish be applied to the unfinished side of the new interior panel? > > Or to the 40-year-old plywood furniture? > > Looking to replace shrunken and/or missing Westfalia white T-molding; any ideas? > > The left side of the bus has no insulation at this time. Shall I attempt to duplicate the > type/amount of stock insulation? > > I would have looked toward the Type2 archive for advice, but it's not available > at this time. Perhaps I am looking in the wrong place/URL. Have a nice weekend, > > -Jack '73 Westfalia > _______________________________________________ > type2 mailing list > type2 at type2.com > https://www.type2.com/lists/type2/listinfo >
- Previous message: [T2] Removed Westfalia's plywood subfloor
- Next message: [T2] Removed Westfalia's plywood subfloor
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the type2 mailing list