[T2] Push rod tubes.

[ka1dza]

Thanks for the info. Where is a good source for them?

Bob Pratt

> On Apr 12, 2015, at 2:34 PM, Jim Denton <2thingswild at gmail.com> wrote:
> 
> Buy quality expandable tubes, don't go cheap and you should be fine.
> 
>> On Sun, Apr 12, 2015 at 10:04 AM, Harris Pat <sammler.permanent at gmail.com> wrote:
>> Not frequently but sometimes the tube may have been incorrectly installed with the seam side down and the leak is from that area. Loosening the head and rotating the tube may be a temporary solution.
>> 
>> The spring loaded 2 piece tubes also are a good temporary solution.
>> 
>> On a 4x4 forum I read about the wonders of "rescue tape".  Sounds like this may also be something to consider.
>> 
>> 
>> Sent from my iPhone
>> 
>> > On Apr 12, 2015, at 12:35, ka1dza <ka1dza at verizon.net> wrote:
>> >
>> > Has anyone used the spring loaded pushrod tubes as replacements? Would this be a reliable and easier solution to fix the oil leak from the tubes?
>> >
>> > Bob Pratt
>> >
>> >> On Apr 12, 2015, at 11:59 AM, DurocShark <durocshark at gmail.com> wrote:
>> >>
>> >> Well, you have to pull the valve covers off, then the rocker train. But you don't have to pull the heads if that's what you mean...
>> >>
>> >>> On Sun, Apr 12, 2015 at 8:57 AM, ka1dza <ka1dza at verizon.net> wrote:
>> >>> Is it possible to replace the seals on the push rod tubs without stripping the engine topside components?
>> >>>
>> >>> Bob Pratt
>> >>> _______________________________________________
>> >>> type2 mailing list
>> >>> type2 at type2.com
>> >>> https://www.type2.com/lists/type2/listinfo
>> >>
>> > _______________________________________________
>> > type2 mailing list
>> > type2 at type2.com
>> > https://www.type2.com/lists/type2/listinfo
>> _______________________________________________
>> type2 mailing list
>> type2 at type2.com
>> https://www.type2.com/lists/type2/listinfo
>