[T2] T2 '70 CV Joints - noise ? & replacement ... need help...
accessys at smart.net accessys at smart.netSat Jul 11 18:45:43 MST 2015
- Previous message: [T2] Fw: T2 '70 CV Joints - noise ? & replacement ... need help...
- Next message: [T2] T2 '70 CV Joints - noise ? & replacement ... need help...
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
by a box of gloves and couple rolls of paper towels. you will use them. not that difficult a job but maybe messiest on bus. Bob PS get the Bentley manual Haynes is really not that good On Sun, 12 Jul 2015, Martin Mikush wrote: > Date: Sun, 12 Jul 2015 01:14:53 +0300 > From: Martin Mikush <martinmikush at gmail.com> > To: Type2 list <type2 at type2.com> > Subject: [T2] T2 '70 CV Joints - noise ? & replacement ... need help... > > Hello > She is a t2 1970 with some improvements. > After reading the Haynes manual and few posts here ant there I think > that I am ready to take on the job - replacing the outer CV Joints > with new ones. > On the 1970 t2 bus I have an intermittent banging noise on the rear > right side - checked the rubber boot - it appears with no cracks but > empty of grease. The banging noise starts after taking sharp turns > with harder acceleration and then disappears. Increases with the > speed. So my assumption is that the CV joints are the culprit. I > acquired the bus from a widow of a guy who did a lot of maintenance on > this bus but no exchange of information was possible in regards of > when and what was done on this beautiful bus. > I read the thread here about using the right washers and dyno to the > right torque too the retaining 6 bolts. Wrote down a note to remind > myself on the groove to be on the inner side - towards the shaft. > I was told that if not replacing all of them I could "rotate" them > -the one from the left side to go on the right side end vice-verca. I > was told that this way I could "extend their life. > Is there anything else I should be aware of before I take on this job? > - it will be my first time replacing CV joints. > Thank you > > _____________________________ > Martin Mikush > mobile: +359 886503058 > http://alchemyarch.wordpress.com/ > Earth Care > ¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯ > _______________________________________________ > type2 mailing list > type2 at type2.com > https://www.type2.com/lists/type2/listinfo >
- Previous message: [T2] Fw: T2 '70 CV Joints - noise ? & replacement ... need help...
- Next message: [T2] T2 '70 CV Joints - noise ? & replacement ... need help...
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the type2 mailing list