[T2] Wiring problems

[ka1dza]

I didn't notice a resistor on the flasher switch even though I saw one in a picture of one from Bus Depot.

How do I check for a bad ground?

Bob Pratt

> On Mar 13, 2015, at 10:20 PM, accessys at smart.net wrote:
> 
> 
> I had major short (almost fire) behind dash when a wire got pinched between gauge panel and frame.   so bad wiring can happen suddenly
> 
> Bob
> 
> 
>> On Sat, 14 Mar 2015, John Kolak wrote:
>> 
>> Date: Sat, 14 Mar 2015 09:11:43 +0700
>> From: John Kolak <jkolak at gmail.com>
>> Cc: t2 <type2 at type2.com>
>> Subject: Re: [T2] Wiring problems
>> It can also be cracked or skinned wiring which can explain why it works
>> when it is removed from the bus but fails again when reinstalled.
>> 
>> On Mar 14, 2015 8:22 AM, "Doyt W. Echelberger" <doyt at buckeye-express.com>
>> wrote:
>> 
>> Fuses blow because of shorts that bypass resistance in the circuit.  Where
>> are the resistors in this circuit?  The bulbs, the flasher unit.  I suspect
>> the flasher unit.
>> _______________________________________________
>> type2 mailing list
>> type2 at type2.com
>> https://www.type2.com/lists/type2/listinfo
> 
> 
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo