[T2] Crankshaft pulley

[Max Bronsema]

Hi Bob,

You should be able to remove the bumper and the middle rear apron that will
expose the engine. Then remove the tin section that is in front of the
pulley. You can then just put on a pulley puller and pop it out and put the
new one on.

Good luck,

Max
'71 Westy "KK-Louise"

On Sun, Feb 21, 2016 at 7:39 PM, Bob Pratt <ka1dza at verizon.net> wrote:

> It's good to see the site up an running again. Thanks all involved.
>
> I just bought a calibrated crankshaft pulley. Is it possible to replace
> the old one with the new one without pulling the engine from a 71 bus?
>
> Thanks in advance.
>
> Bob Pratt
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo




-- 
Max Bronsema