[T2] Crankshaft pulley

[Bob Pratt]

Thanks everyone for the advice. The pulley replacement is on the list after the new wiring harness goes in and everything electrical works.

Bob Pratt

> On Feb 21, 2016, at 11:07 PM, accessys at smart.net wrote:
> 
> 
> a 71 should be fairly easy since the rear flange can be removed unlike most other years.
> remove bumper
> then rear flange
> and should have straight shot at the crank pully
> they usually are fairly easy to remove
> 
> Bob
> 
> 
>> On Sun, 21 Feb 2016, Bob Pratt wrote:
>> 
>> Date: Sun, 21 Feb 2016 22:39:42 -0500
>> From: Bob Pratt <ka1dza at verizon.net>
>> To: type2 at type2.com
>> Subject: [T2] Crankshaft pulley
>> It's good to see the site up an running again. Thanks all involved.
>> 
>> I just bought a calibrated crankshaft pulley. Is it possible to replace the old one with the new one without pulling the engine from a 71 bus?
>> 
>> Thanks in advance.
>> 
>> Bob Pratt
>> _______________________________________________
>> type2 mailing list
>> type2 at type2.com
>> https://www.type2.com/lists/type2/listinfo
> 
>