[T2] Fwd: Vw westfalia 1978 010 tranny advice or help

[accessys at smart.net]

sounds like the shifter linkage is not adjusted correcttly

follow the BENTLEY manuaul EXACTLY it is complicated and must be done 
correctly for all the gears to work properly

hope this helps
Bob



On Tue, 14 Jun 2016, Jim Arnott wrote:

> Date: Tue, 14 Jun 2016 19:09:54 -0700
> From: Jim Arnott <jrasite at eoni.com>
> To: vanagon <vanagon at gerry.vanagon.com>, Type2 <type2 at type2.com>
> Subject: [T2] Fwd: Vw westfalia 1978 010 tranny advice or help
> 
> Sent to the vanagon list admin address. Please reply to Pablo directly as he’s not on either Vanagon nor Type2.
>
> TIA,
>
> Jim
>
>
>
>> Begin forwarded message:
>>
>> From: pablo vial de ruyt <pablo_vent at hotmail.com>
>> Subject: Vw westfalia 1978 010 tranny advice or help
>> Date: June 14, 2016 at 4:09:07 PM PDT
>> To: "vanagon-request at gerry.vanagon.com" <vanagon-request at gerry.vanagon.com>
>>
>> Hi Gerry.vanagon;
>>
>> I Pablo from Chile, your advice will be too much important for me......Recently refresh my 010 automatic transmission (westfalia 1978), before rebuilt work slipping and old seals and clutches.
>> After install master kit and pistons (made in USA) appear new problem, 3º gear in "D" position does not work, not upshift, only works  1 and 2 speed, and reverse gear sometimes work fine. but on occasion, Especially when stopping for only a few minutes after driving for a bit. I put the selector in reverse and nothing for a few seconds, then sometimes it engages smoothly other times it engages very hard with a definite "thunk".
>> The specialist in my country has been check it all again two times without success ..... He tells me that only thing that may be happening is that the valve body has a internal failure.
>>
>> Any similar opinion or experience?
>>
>>
>>
>> Thank you and Best regards
>
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo
>