[T2] Heater controls?

[Andy McKinley]

Kevin, I was just looking into that. If you look inside the dash at where
the cables attach to the controls, you'll see that there are actually four
cables attached to the two control levers. Look at the fiche on Ratwell's
site.

On Nov 3, 2017 7:31 AM, "Kevin Guarnotta" <kevin at guarnottadesign.com> wrote:

> Ok - more stuff on my '78 westy. To work on/access the shift rod I removed
> the big accordion style duct that runs up to the front of the bus. A few
> questions before I put it back together -
>
>   1.  For my '65 this is a metal tube, I insulated it with come closed
> cell foam type insulation. Currently the tube on my '78 has no insulation.
> I was thinking of putting some insulation on it - anyone else done this?
> Maybe I could replace the tube with a PVC pipe, then put the insulation
> around that, or just put the insulation around the accordion style duct
> work.
>   2.  Where this flex tube attaches near the front of the bus, the duct
> work appears to sort of 'Y' off. There are two flaps covering these side
> ducts, that are spring loaded, and appear as though there should be
> something attached to the flaps, but I don't see anything there. Anyone
> know what I'm talking about? I can't find a diagram online to understand
> how this was supposed to work.
>   3.  There is some minor surface rust on some of these pieces/metal duct
> work. I think I'll clean them up and do a little touch up paint. Hope the
> smell isn't too bad when I run the heat.
>
> -Kevin Guarnotta
> Jamaica Plain, MA
>
> '78 Westy
> '69 Singlecab
> '65 Ez-camper
>
>
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo