[T2] Dipstick length

[Snoopy]

11 3/8 inches. Tip to handle 

Please excuse the brevity or typos in this email. Sent from my iPhone

> On Jun 19, 2018, at 4:42 PM, Greg Potts <slowlanemusic at icloud.com> wrote:
> 
> I could, but I already have a 914 sump plate sensor installed on this motor; connected to a gauge from an early rabbit convertible.
> 
> All I require is an accurate measurement of the length from the shank (handle) to the tip, and from the handle to the add mark. Then I can add a handle to a brass or steel rod and mark it accordingly.
> 
> Greg Potts
> 197x Westfakia “Bob the Tomato”
> Www.pottsfamily.ca
> 
> 
>> On Jun 19, 2018, at 9:42 AM, Sami Dakhlia <sami.dakhlia at gmail.com> wrote:
>> 
>> Greg,
>> You could get a temp sensing dipstick, while you're at it.
>> Gene Berg used to have one, but there may be other suppliers, too.
>> Cheers,
>> Sami
>> 
>> On Mon, Jun 18, 2018 at 7:21 PM Greg Potts <slowlanemusic at icloud.com> wrote:
>> Hi Volks,
>> 
>> I’m upgrading the engine in the westfakia from a 1.7L EA series (914 and 411) motor to a 2.0L GD series (late bay window) . One of the best parts of that conversion will be going back to the original oil filler tube and dipstick rather than the top mounted tube and filler used on the 411/412/914. 
>> 
>> But... the engine I bought didn’t come with a dipstick. So I was hoping someone out there could please tell me the measurements I need to fabricate one for myself. 
>> 
>> Happy Trails,
>> 
>> Greg Potts
>> 197x Westfakia “Bob the Tomato”
>> Www.pottsfamily.ca
>> _______________________________________________
>> type2 mailing list
>> type2 at type2.com
>> https://www.type2.com/lists/type2/listinfo
> 
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo