[T2] fuel line

[Bob Pratt]

I've had a hard time finding non screw type fuel clamps to fit my fuel lines.

Bob

> On May 13, 2018, at 6:12 PM, accessys at smart.net wrote:
> 
> 
> make sure you DON'T use regular hose clamps but rather the stainless compression clamps that don't cut the hose.
> 
> Bob
> 
>> On Sun, 13 May 2018, c.dreike wrote:
>> 
>> Date: Sun, 13 May 2018 14:48:54 -0700
>> From: c.dreike <c.dreike at verizon.net>
>> To: "type2 at type2.com" <type2 at type2.com>
>> Subject: Re: [T2] fuel line
>> Your local FLAPS should have some good fuel resistant line. Diameter is the only problem you might have.
>> 
>> Chris
>> 64DD Kamper Kit (fuel injected)
>> 
>>> On 5/13/2018 2:04 PM, Erik Burtis wrote:
>>> I've been using gates barricade fuel line on my 71 for going on 5 years now
>>> without an issue.
>>> On Sun, May 13, 2018 at 2:11 PM, Ric Jablonski <ricjablonski at gmail.com>
>>> wrote:
>>>> Upright engine. Gas smell. Just noticed one braided line is saturated. Very
>>>> lucky I was not driving.
>>>> What is the consensus on the best replacement fuel line that will be
>>>> readily available. Anyone remember the size right off?
>>>> Ric
>>>> --
>>>> -Sent from private E-mail address.-
>>>> _______________________________________________
>>>> type2 mailing list
>>>> type2 at type2.com
>>>> https://www.type2.com/lists/type2/listinfo
>>> _______________________________________________
>>> type2 mailing list
>>> type2 at type2.com
>>> https://www.type2.com/lists/type2/listinfo
>> 
>> _______________________________________________
>> type2 mailing list
>> type2 at type2.com
>> https://www.type2.com/lists/type2/listinfo
> 
> 
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo