[T2] Improved ride quality

[Chris Dreike]

David,
Thanks for the comments. I have compared my ride height to 3 other
splitties of varying ages and all are at the same height. So I think that
my bus has not sagged. (no guarantee of course with hardware this old)
Having removed the stops and driven around for about 25 miles, I am much
happier with the ride quality. So I have ground off about 3/8" of rubber
from my stops with a wire wheel and I will be reinstalling them today.
Next experiment will be to reduce the front tire pressure to about 22-24
psi. The factory recommends 28 in the front and 32 in the rear.
I hope to report back on that later.
A while back I had a conversation with Peter at Airkewld about the ride
quality. I had asked about removing a torsion leaf to reduce the spring
rate and installing an adjuster to lift the front back up to stock. His
answer was that it is a bad idea to
remove a leaf and to try removing the stops and lowering air pressure. So
that is where I am at right now.

BTW, my modified brake arm makes driving the bus much more delightful.
Please let me know if any of you folks try this and how you like it.

Cheers,
Chris
64DD Kamper Kit
71 Sunroof

On Fri, Aug 30, 2019 at 8:46 AM david raistrick <keen at icantclick.org> wrote:

> > I still think the suspension was bottoming onto the rubber stops. The
> gap between the top of the
> trailing arm and the rubber was very short.
>
> based on your descriptions, I'd agree.   it sounds like you have a reduced
> suspension travel from stock.   I'd guess that you may be suffering spring
> sag, which is pretty common, particularly on campers.    for rears, it's a
> torsion bar adjustment to bring it up.   for front it's a bit harder, since
> the stock beams dont have adjustability.   Of course, you could have a
> broken spring leaf, which is also common.    could be worth a beam teardown
> to find out.     You can add (or have added) an adjuster, and use it to
> raise (to stock height), instead of lower, the front.
>
> it's pretty common for the lowered crowd to have to cut or remove the bump
> stops.  it's not really normal for the stock height crowd. ;)
>
>
>