[T2] Gas issue
Nancy Hairston nhairsto73 at gmail.comTue Feb 18 11:38:30 PST 2020
- Previous message (by thread): [T2] Gas issue
- Next message (by thread): [T2] Gas issue
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Can anyone tell me what insurance you use for your VW? Thanks, Nancy > On Feb 18, 2020, at 11:47 AM, Dave Gillingham <dave at coronado-realty.com> wrote: > > Fellow Bussers: > > I recently attended a meeting of a Corvette Club at the invitation of one > of my knuckle dragger friends. I figured I could go along as the adult > supervision :) . The meeting was at a private museum in Carson and the cars > (mostly Mopar and Corvette) were incredible. Some really unique vehicles. > > There was also a tech session on the dangers of pump gas - at least in CA. > Turns out the ethanol added to essentially all pump gas in CA does really > bad things to the carbs and rubber fuel lines on older cars. For reasons I > don't understand, later model cars with "closed" fuel systems are not > affected. As evidence, the presenter passed around a Holley carb for us to > look at. The accelerator pump tunnel was badly corroded! Anyway the > recommendation was to use an additive when filling your gas tank. it > convinced me. > > Fast forward a couple of months and my bus (73 Panel van with a 2.0 and > dual Kadrons) wouldn't start one morning. After futzing around with it I > determined it to be a fuel problem. Neither carb was getting gas. I have > an almost new (and expensive) fuel pump, and I had recently changed the > main gas line (I try to do that annually) and all three filters. Closer > inspection revealed that the filters were all dirty! So I again > changed the filters together with the fuel lines, only to discover that my > right side carb had a stuck needle valve (new Kadrons that are less than 4 > months old!). > > So lesson learned: I suspect the fuel additive effectively cleaned my gas > tank and then clogged my filters. A small piece of grit may have also > jammed the needle valve. But perhaps most important: There is a chance > that the rubber fuel lines were collapsing from the inside. Evidently, > rubber or braided lines are easily deteriorated by the new gas mix. At my > next available day off I am going to fabricate some steel lines for as much > of the delivery route as possible and plan to change the rubber connectors > regularly. > > My $.02 > > Dave Gillingham, Owner/Broker > > License # 01184185 > > o: (619) 435-0145 > > m: (619) 992-5318 > > e: dave at coronado-realty.com <natalie at coronado-realty.com> > > a: 1111 9th St #202, Coronado, CA 92118 > _______________________________________________ > type2 mailing list > type2 at type2.com > https://www.type2.com/lists/type2/listinfo
- Previous message (by thread): [T2] Gas issue
- Next message (by thread): [T2] Gas issue
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the type2 mailing list