[VB] [T2] 2nd Gear Problems

[Kevin Guarnotta]

I see I don't need to pull the engine to replace the shift coupler, but after pulling the shift coupler from the rear of the rear shift rod, and the coupler from the front of the shift rod - how do you get the shift rod out?  Don't I need to take the shift rod out - to install the bushings on either end? 
The shift rod appears to be one piece, with a curved end, going through a tube. The curved end is in the rear, and so I think I would need to pull the rod out from that side -but the transmission is there?

-Kevin Guarnotta
Jamaica Plain, MA

’78 Westy
'69 Singlecab
'65 Ez-camper


-----Original Message-----
From: Dan Bessom [mailto:grtfldan at gmail.com] 
Subject: Re: [T2] 2nd Gear Problems

You don’t need to pull the engine. 1 bolt 1 square bolt.
Dan

Sent from my iPhone