[T2] Binding Clutch

[Al Brase]

yes. But not usually. It will make quite a bit of noise when held in.
Al

On Sat, Jul 15, 2017 at 12:27 PM, Bradley Spear <my13jetta at gmail.com> wrote:

> Could the pilot bearing be going out?
>
> On Jul 15, 2017 12:18, <rondunn at juno.com> wrote:
>
> > ’70 bus
> > Replaced clutch with diaphragm assembly and new throw-out 15 years ago.
> > Replaced cable 3 years ago.
> > Shifting became difficult causing frequent tightening of cable.
> > Cable is now full tight (minimal free play) with full travel of throw-out
> > arm, but clutch will not completely disengage.
> > Must be diaphragm fingers are bending, or some other internal problem.
> > Any other thoughts on the subject.
> >
> > rondunn at juno.com
> > _______________________________________________
> > type2 mailing list
> > type2 at type2.com
> > https://www.type2.com/lists/type2/listinfo
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo
>