[T2] Binding Clutch

[Snoopy]

How is the Bowden Tube and the bolt that holds it to body?

Please excuse the brevity or typos in this email. Sent from my iPhone

> On Jul 15, 2017, at 1:35 PM, Al Brase <alribee at gmail.com> wrote:
> 
> yes. But not usually. It will make quite a bit of noise when held in.
> Al
> 
>> On Sat, Jul 15, 2017 at 12:27 PM, Bradley Spear <my13jetta at gmail.com> wrote:
>> 
>> Could the pilot bearing be going out?
>> 
>>> On Jul 15, 2017 12:18, <rondunn at juno.com> wrote:
>>> 
>>> ’70 bus
>>> Replaced clutch with diaphragm assembly and new throw-out 15 years ago.
>>> Replaced cable 3 years ago.
>>> Shifting became difficult causing frequent tightening of cable.
>>> Cable is now full tight (minimal free play) with full travel of throw-out
>>> arm, but clutch will not completely disengage.
>>> Must be diaphragm fingers are bending, or some other internal problem.
>>> Any other thoughts on the subject.
>>> 
>>> rondunn at juno.com
>>> ______________________________________________