[T2] [Q] Dropping Transmission
Dan Bessom grtfldan at gmail.comTue Jun 26 18:15:41 PDT 2018
- Previous message (by thread): [T2] [Q] Dropping Transmission
- Next message (by thread): [T2] Voltage regulator
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
You can remove gas tank without pulling the engine, but itâs very frustrating. Dan On Tue, Jun 26, 2018 at 7:56 PM david raistrick <keen at icantclick.org> wrote: > On Tue, Jun 26, 2018 at 7:41 PM, Davepatwms <davepatwms at tds.net> wrote: > > Cn you remove the gas tank from a 1973 bus without pulling the engine? > > Thanks, Dave. > > sure - you just have to remove everything in the way. that means the > carbs, manifold, etc etc. you can even do it with an upright, but > stripping the top of an upright in the engine compartment is a lot > harder. :) > > when you remove the firewall panel you'll have a good visual reference > for what needs to come off. > > is it less work than dropping the engine? not really, unless you're > not equipped to do that. especially on a t4 where you can just lower > the assembly out of the way.... unbolt the front trans mount, the rear > engine mounts, and maybe the upper trans mount if you have one, and > lower it down. > _______________________________________________ > type2 mailing list > type2 at type2.com > https://www.type2.com/lists/type2/listinfo -- Dan B 703 861 9633
- Previous message (by thread): [T2] [Q] Dropping Transmission
- Next message (by thread): [T2] Voltage regulator
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the type2 mailing list