[T2] why it won't start

[Pat Spragge/RFAN]

with ether it sputters but still won't run.  (but at least isn't 
backfiring)

Sputters?  Does it sound like it is about to start or does it sound like 
only a couple of cylinders are firing?  When you checked spark, did you 
check all 4 cylinders/plugs? If it runs a sec or two on ether that would 
tend to indicate a fuel problem. Otherwise, spark/timing is suspect.
If fuel is the problem, would check pressure. If it doesn't sound like it 
is almost running on ether, I would chase spark issues.

There is something very basic that is being overlooked....gotta be fuel or 
spark. 

Pat



From:   accessys at smart.net
To:     Ken Madson <kenm at thebusco.com>, 
Cc:     type2 at type2.com
Date:   06/09/2015 10:50 AM
Subject:        Re: [T2] why it won't start
Sent by:        "type2" <type2-bounces at type2.com>




went over everything with fine tooth comb.

. compression 115-120
. getting fuel injector firing
.  moved wire on coil that was on wrong terminal (thanks Jamie)
. hot spark
. checked valve lash. (hydr)
. reset timing

with ether it sputters but still won't run.  (but at least isn't 
backfiring)
am debating draining gas and putting in fresh.???

any other suggestions..???

thanks
Bob
(ps - 78 FI with auto tranny)



On Mon, 8 Jun 2015, Ken Madson wrote:

> Date: Mon, 8 Jun 2015 19:23:40 -0700
> From: Ken Madson <kenm at thebusco.com>
> To: accessys at smart.net
> Subject: why it won't start
> 
> Have you done a compression check? (I know it is a new motor, but . . .)
>
>
>
> I have had customers adjust hydraulic lifters in a turn or so and not 
have
> any compression
>
>
>
> Regards,
>
> Ken Madson
>
>
>
> The Bus Company
>
>
>
>
>
>


_______________________________________________
type2 mailing list
type2 at type2.com
https://www.type2.com/lists/type2/listinfo